IBM totalstorage 326, Справочник пользователя

Страница: 102 / 240

The symptom appears in the left column of the table. Instructions and probable
solutions to the problem are in the right column. If you have just added new
software or a new option and the Model 326 engine is not working, do the following
before using the troubleshooting charts:
1. Remove the software or device that you just added.
2. Run the diagnostic tests to determine if the Model 326 engine is running
correctly.
3. Reinstall the new software or new device.
Table 9. Engine troubleshooting symptoms and actions
Error Symptom CRU/action
CD is not working correctly.
1. Clean the CD .
2. Run CD-ROM diagnostic.
3. CD-ROM drive.
CD-ROM drive tray is not working.
1. Ensure the appliance is powered ON .
2. Insert the end of a paper clip into the manual tray-release opening.
3. Run CD-ROM diagnostic.
4. CD-ROM drive.
CD-ROM drive is not recognized.
1. Run Configuration/Setup; enable primary IDE channel .
2. Check cables and jumpers.
3. Check for correct device driver.
4. System board.
5. Run CD-ROM diagnostics.
6. CD-ROM drive.
Power switch does not work and reset
button does work.
1. Verify that the power-on control jumper on J23 extension cable is
on pins 1 and 2
.
2. Power switch assembly.
3. System board.
Diskette drive in-use LED stays on, the
system bypasses the diskette drive, or
the diskette drive does not work.
1. If there is a diskette in the drive, verify that:
a. The diskette drive is enabled in the Configuration/Setup utility
program
.
b. The diskette is good and not damaged (try another diskette if
you have one)
.
c. The diskette is inserted correctly in the drive .
d. The diskette contains the necessary files to start the
appliance
.
e. The program is OK
f. The cable is installed correctly (correct orientation) .
2. Run diskette-drive diagnostics.
3. Cable.
4. Diskette Drive.
5. System board.
90
Model 326 User’s Reference