IBM totalstorage 326, Справочник пользователя

Страница: 179 / 240

Table 31. Hub diagnostic error messages (continued)
Message Description Probable cause Action
DIAG-ERRSTAT
Err#2640-2647, 3040-3047,
3840-3847 [portLoopbackTest,
crossPortTest, spinSilk] Port error statistics counter
is non-zero, meaning an
error was detected when
receiving frames. One of
the following status errors
occurred:
v
Enc_in - Encoding error,
inside frame
v
CRC_err - Cyclic
redundancy check on
frame failed
v
TruncFrm - Truncated
frame
v
FrmTooLong - Frame too
long
v
BadEOF - Bad end of file
v
Enc_out - Encoding
error, outside frame
v
BadOrdSet - Bad symbol
on fiber-optic cable
v
DiscC3 - Discarded class
3 frames
ASIC, system
board, GBIC
module, embedded
optic or fiber cable
failure 1
DIAG-INIT Err#264F, 304F,
384F [portLoopbackTest,
crossPortTest, spinSilk] Port failed to go active in
the loopback mode
requested. ASIC, system
board, GBIC
module, embedded
optic or fiber cable
failure 1
DIAG-INTNIL Err#2031
[cmiTest] ASIC failed to get a CMI
error (interrupt). ASIC failure 1
DIAG-INTNOTCLR Err#102C
[centralMemoryTest] The interrupt bit could not
be cleared. ASIC failure 1
DIAG-LCMEM Err#1027
[centralMemoryTest,
cmemRetentionTest] Data read from the central
memory location did not
match data previously
written into the same
location. ASIC failure 1
DIAG-LCMEMTX Err#1F27,
1028 [centralMemoryTest] Central memory transmit
path failure: ASIC 1 failed
to read ASIC 2 using the
transmit path. System board
failure 1
DIAG-LCMRS Err#1F25, 1025
[centralMemoryTest,
cmemRetentionTest] Central memory read short:
M bytes requested but got
less than M bytes. ASIC failure 1
DIAG-LCMTO Err#1F26, 1026
[centralMemoryTest,
cmemRetentionTest] Central memory timeout:
Data transfer initiated did
not complete within the
timeout period. ASIC failure 1
DIAG-MEMNULL Err#0112
[ramTest] Test failed to malloc. System board
failure 1
DIAG-MEMSZ Err#0111
[ramTest] Memory size to be tested is
less than or equal to zero. System board
failure 1
Appendix E. Setup procedures and diagnostics for the Fibre Channel Hub
167