IBM totalstorage 326, Справочник пользователя

Страница: 169 / 240

Parity None
Stop bits 1
Flow control None
Then click OK .
6. Connect and then press Enter on the terminal screen.
7. At the Admin> prompt type ipAddrSet and press Enter .
8. Type in an IP address.
9. Type in a subnet mask.
10. Enter the Fibre Channel IP address, if needed, and press Enter . If not needed,
press Enter .
11. Enter Fibre Channel subnet mask, if needed, and press Enter . If not needed,
press Enter .
12. Enter Gateway Address IP address, if needed, and press Enter . If not needed,
press Enter .
13. After you have entered all the information, you are prompted to either apply
changes immediately or to reboot. You may do either, but you will need to do
either before you use the address.
14. Connect the hub or switch to your Ethernet network.
Notes:
1. It is possible that your machine will need a plug-in to connect and manage the
hub or switch through a browser. The browser will identify the plug-in and
specify the location and steps to download the plug-in.
2. If prompted for a user ID and password, use admin and password .
3. For complete documentation, refer to the IBM 3534 SAN Fiber Channel
Managed Hub User’s Guide or the 2109 Model Sxx User’s Guide .
Running diagnostics on the hub
There are three methods to access the hub for running diagnostics. All methods
involve the use of Telnet commands and differ only in the initial login requirement
and the access level given to the user.
Attaching to the serial port while the hub is off
1. If you can attach your service terminal to the hub before turning it on, you are
automatically logged on as the administrator ID and can issue all diagnostic
commands. You can watch the progress of the POST diagnostics as they are
posted to your service terminal.
2. If you can attach this way, attach your service terminal to the serial port on the
front of the hub and start a terminal emulation session on your service terminal.
3. Start up the hub by plugging the power cord into an electrical outlet.
4. As the hub executes a POST, you will see the results posted.
5. When the hub has completed POST, you are logged on as administrator. The
hub leaves the terminal session open. Press Enter . The hub responds with:
Admin>
6. You can perform any of the diagnostics described in this section by typing the
appropriate command. The hub shows the results as the diagnostic progresses.
Appendix E. Setup procedures and diagnostics for the Fibre Channel Hub
157