IBM totalstorage 326, Справочник пользователя

Страница: 16 / 240

After you determine how you will manage the Model 326, you can begin
setup and configuration of the device.
For more information on configuration and administration tools, see
“Chapter 2. Configuration and administration tools” on page 9.
Step 1 - Initial network setup
Configure both nodes to enable access over the network. The general steps
to do this are given below. More details are given in “Chapter 3. Getting
started” on page 25.
1. Use Dynamic Host Configuration Protocol (DHCP) or static addressing
to set up one public network connection in each node.
a. If you are operating with a keyboard, display, and mouse, set up a
public network connection to access the device.
b. If you are operating in a headless environment, use one of the
following methods:
v
If DHCP is installed and the IP address requested can be
determined, you can use DHCP for initial setup, but you should
change this address to static later in the configuration.
v
If you have multiple appliances or cannot determine the DHCP
address, you can install the IAACU utility to identify appliances
and define IP addresses. The tool will also allow you to set static
addresses.
2. Complete the steps in “Setting the date and time” on page 27 and
“Setting up the network” on page 27.
Step 2 - Define shared storage and setup partitions
The Model 326 comes with preconfigured shared storage spanning nine
disks. The storage is formatted as an array, at RAID-level 5, consisting of
the following logical unit numbers (LUNs):
v
A LUN of 500 MB, for the Quorum drive (drive letter G )
v
A second LUN, composed of the remaining space and used as a shared
drive with one built-in hot spare
To use this default, preconfigured storage, validate all storage areas and
determine that the drive letters are the same on each node.
Otherwise, from one of the two nodes, define all storage arrays using
Storage Manager and then set up Windows partitions as defined in
“Chapter 4. Setting up storage” on page 29.
Attention: When you set up the shared storage, you must configure the
storage on one node only. During the setup of shared storage, leave the
joining node powered off.
Step 3 - Complete network setup and cluster installation
1. Power on either node. (This becomes the first node.)
2. Set up the first node:
a. Networking setup
See “Networking setup” on page 37. Note the cautionary statement
at the beginning of that section.
b. Domain setup
See “Joining a node to a domain” on page 40.
4
Model 326 User’s Reference