IBM totalstorage 326, Справочник пользователя

Страница: 37 / 240

Chapter 3. Getting started
This chapter gives details to set up the initial communication to the Model 326 to
enable setup and configuration. These instructions refer specifically to a base
configuration as shipped and do not cover the setup of additional storage units,
which can be purchased separately.
Note: You must follow these procedures for both nodes.
Methods for setting up the Model 326
The following sections detail how to set up the Model 326. You must first ensure
that the network recognizes the new appliance. Which method you should use
depends on several conditions:
v
In “headless” mode (without a keyboard, monitor, and mouse directly attached to
the unit), use one of the following methods:
– IBM Advanced Appliance Configuration Utility
If you have multiple appliances or cannot determine the DHCP address, install
the IAACU to identify appliances and define IP addresses. The tool also
allows you to set static addresses.
If you are using this method, proceed with “Installing the IBM Advanced
Appliance Configuration Utility”.
– Windows Terminal Services
If DHCP is installed and the IP address requested can be determined, use this
method for initial setup, but you should change the address to static later in
the configuration. This condition is most appropriate when using Windows
Terminal Services for operation of the Model 326.
If you are using this method, proceed with “Initial setup and configuration” on
page 26.
v
The use of a keyboard, display, and mouse is most appropriate when there is a
single or few appliances in the network and you use static setup and definition.
If you are using this method, proceed with “Initial setup and configuration” on
page 26.
Installing the IBM Advanced Appliance Configuration Utility
These instructions assume that you have installed and powered on the appliance
according to the installation guide procedures. You are now ready to install the
IAACU Console application from the Supplementary CD.
Install the Advanced Appliance Configuration console application from the
Supplementary CD onto a Windows NT 4.0 or Windows 2000 workstation that is
attached to the same IP subnetwork to which the appliance is attached.
Note: The IAACU creates a private database that is specific to the IP subnetwork
to which it is attached. Therefore, do not install it on more than one systems
management console residing on the same IP subnetwork.
For information on how to install the IAACU Console, see Table 23 on page 126.
After you install the Advanced Appliance Configuration console application, the
following steps will take you to the point where you can administer the appliance.
© Copyright IBM Corp. 2002
25