IBM E10, Руководство по обслуживанию, Страница: 119 / 279

Table 10. SP Checkpoints. (continued)
Checkpoint Description Action/ Possible Failing FRU
E080 Entering Service Processor emergency
firmware flash recovery process. Call the next level of support before doing the
following:
1. I/O Planar, OR
2. Insert a new DOS formatted diskette
containing the service processor firmware
into the diskette drive. The image file
name must be spflash.img.
Note: ONLY insert the diskette after the
operator panel displays E080 code.
3. Power the cluster off then on and rerun
the flash recovery.
E081 Flash update completed - system reboot in
progress
1. Power the cluster off then on and rerun
the flash recovery.
2. Retry a service processor emergency
flash update (if possible) as documented
in the checkpoint code E080.
3. I/O Planar, see 1 on page 100
4.
5.
E0A0 Beginning Bring-Up Phase
1. Service Processor (E10/E20 only)
2. CPU Card
3. I/O Planar (See notes on 72 )
E0B0 Starting CPU BIST
1. CPU Card
2. I/O Planar (See notes on 72 )
3. Service Processor (E10/E20 only)
E0C0 Starting X5 BIST
1. CPU Card
2. I/O Planar (See notes on 72 )
3. Service Processor (E10/E20 only)
E0D0 Creating scan log is slow, wait for completion None
E0E0 Pulling CPU out of reset
1. CPU Card
2. I/O Planar (See notes on 72 )
3. Service Processor (E10/E20 only)
E0E1 Pull CPU out of reset: OK
1. CPU Card
2. I/O Planar
3. System Planar (See notes on 72 )
4. Service Processor (E10/E20 only)
E164 Create PCI graphics node (P9) See 1 on page 100
E168 Create PCI graphics node (S3) See 1 on page 100
E16C GTX100P Subsystem Open request See 1 on page 100
E16D GTX100P planar not detected or failed
diagnostics See 1 on page 100
E16E GTX100P subsystem open successful See 1 on page 100
E16F GTX100P See 1 on page 100
E240 Setup Winbond ISA bridge I/O Planar, see 1 on page 100
Codes
Error Messages, Diagnostic Codes, and Service Reports, CHAPTER 9
103