IBM BladeCenter S SAS RAID Controller Module, Инструкция по установке и эксплуатации

Страница: 157 / 216

9511 Volume volume_ID data redundancy error encountered - Bad blocks created in LBA range LBA1 to
LBA2
Explanation: Redundancy scan found and corrected incoherency, but created bad blocks.
System action: By default, the SAS RAID Module system information indicator is turned on and the operator is
notified of this alert by e-mail.
Operator response: Acknowledge to clear the alert immediately. Rewrite affected volume LBAs if possible.
9512 Volume volume_ID migrate incomplete and source group is missing. Volume has been deleted.
Explanation: Volume migrate was suspended or interrupted, and source group is not available at system reboot
time.
System action: By default, the SAS RAID Module system information indicator is turned on and the operator is
notified of this alert by e-mail.
Operator response: Acknowledge to clear the alert immediately.
Host and connectivity alerts
The alerts in this section are generated to inform the operator of changes in host or
connection status.
4601 Controller host port connectivity error
Explanation: Controller detected an unexpected loss of connectivity on an enabled host port.
v
For a FibreChannel host port, this alert is generated when a link down condition is detected on the host port.
v
For a SAS host port, this alert is generated when a 106x internal fault condition requires a 106x reset.
v
This alert is not generated for an Apache host port.
System action: By default, the SAS RAID Module system information indicator is turned on and the operator is
notified of this alert by e-mail. Alert clears when the host port connectivity is restored.
Operator response: Replace the controller or host switch.
This alert can be masked so that it does not trigger the SAS RAID Module system information indicator.
5600 Illegal host host_ID access attempted
Explanation: An invalid SCSI initiator port (host) has attempted to access the system.
v
For a FibreChannel host port, this alert is generated when a PLOGI frame is received from a host that does not
have any LUNs mapped to it.
v
For all other types of host ports, this alert is generated when a SCSI command is received from a SCSI initiator
port (host) that does not have any LUNs mapped to it.
System action: By default, the SAS RAID Module system information indicator is not turned on and the operator is
not notified of this alert by e-mail. Alert clears when the host becomes valid by being added to the system. Alert
clears automatically after 120 seconds.
Operator response: Acknowledge to clear the alert immediately. Add host and map LUN to allow access.
9511 • 5600
Chapter 11. Troubleshooting and support
147