IBM BladeCenter S SAS RAID Controller Module, Инструкция по установке и эксплуатации

Страница: 97 / 216

datascrub
The
datascrub
command views or sets the
datascrub
policy.
The
-auto
flag specifies whether background scrub should be enabled. If a problem
is found, the policy to fix it or create bad blocks is defined in the flash
configuration file.
Command arguments:
<CLI> datascrub –[get | set –auto [on|off]
Where:
v [on|off]
- Enables or disables data scrubbing.
Example:
<CLI> datascrub -get
Data Scrub Policy is off
delete all
Important: This command produces a destructive procedure causing complete
data loss. Use this command only if your intention is to irrevocably erase all disk
data.
The
delete all
command deletes all pools, volumes, and host LUNs in a bound
controller system. Use this command to delete an existing configuration before
loading a new configuration manually or from a configuration script.
Command arguments:
<CLI> delete all
Example:
<CLI> delete all
All volumes in the system and hostluns mapped to them will be unavailable
(deleted). The data for these volumes will be deleted. Do you want to
continue? Type 'L’ to delete or any other key to cancel.
L
Started deleting all...
Delete All Successful
expand -volume
Use the
expand -volume
command to expand the capacity of a volume. The new
capacity of a volume is equal to the added capacity increment plus the old volume.
The incremental capacity can be defined in MB, GB or the percentage (%) of the
total remaining drive pool capacity.
Note: If the remaining capacity on the pool is less than the requested expansion,
an error occurs.
Command arguments:
<CLI> expand -volume poolname:volumename -add capacityIncrement [MB|GB|%]
Where:
v poolname:volumename
- Allows selection of the volume name as a combination of
poolname
and
volumename
.
v capacityIncrement
- Specifies the number for the incremental capacity.
Chapter 8. Using the RAID Controller command line interface
87