IBM BladeCenter S SAS RAID Controller Module, Инструкция по установке и эксплуатации

Страница: 96 / 216

| 4| ACCESS_READWRITE| raid5_0:vol01|
| 5| ACCESS_READWRITE| raid5_0:vol02|
|_________|_____________________|___________________________|
Running this command with the
-unmap
option unmaps the host LUN from a
volume.
Example:
<CLI> hostlun –unmap –wwn 500062b00008ace9 –lun 4
Lun 4 for host 500062b00008ace9 unmapped.
Volume services commands
Use the SAS Switch command line interface for the RAID controller to perform
administrative tasks for the device. This topic details commands related to volume
services.
add capacity
The
add capacity
command expands the capacity of a drive pool by adding a new
unassigned drive or drives to the pool. The number of drives you add to the pool
is dependant on the RAID level configured on your system. For RAID levels 1 and
10, you add two drives to the pool at a time. If you are operating a RAID level of
0 or 5, you add one at a time. If the capacity of the new drive is less than the
capacity of the smallest drive in the pool, the system generates an error. However,
if the capacity of the new drive is more than the capacity of the smallest drive in
the pool, the system generates a warning.
Command arguments:
<CLI> add capacity –pool name –drivelist <[ENCLOSURE]:[TRAY]>
<[ENCLOSURE]:[TRAY]> .. <[ENCLOSURE]:[TRAY]>
Where:
v name
- Defines the pool name.
v [ENCLOSURE]:[TRAY] - Specifies the drive bay number by enclosure number and
drive position (tray) number. You can add one or more drives to the pool.
Example:
<CLI> add capacity –pool Group0 –drivelist 1:3
Capacity added successfully
86
IBM SAS RAID Controller Module: Installation and User's Guide IBM BladeCenter S SAS RAID Controller Module