IBM BladeCenter S SAS RAID Controller Module, Инструкция по установке и эксплуатации

Страница: 25 / 216

Installing the Battery Backup Unit
To install the Battery Backup Unit, slide the unit into the media tray and close the
release handle.
About this task
This topic shows the mechanics of performing a physical installation of the Battery
Backup Units. The Replacing a battery section of this document details the steps to
take to prepare the IBM BladeCenter S SAS RAID Controller Module for a battery
replacement.
Battery Backup Unit installation into the front of the BladeCenter S chassis
Procedure
1. Open the release handle (rotate the handle down).
2. Slide the battery backup unit into the media tray.
3.
Close the release handle (rotate the handle up)
Removing the Battery Backup Unit hardware
To remove the Battery Backup Unit, open the release handle on the Battery Backup
Unit and slide the bBattery Backup Unit out of the media tray.
About this task
Important: If you are removing one or both Battery backup units from a
BladeCenter S chassis that contains SAS RAID controller modules, refer to the IBM
BladeCenter SAS RAID Controller Installation and User's Guide for additional steps
that might need to be performed.
Chapter 2. Prerequisite hardware
15