IBM BladeCenter S SAS RAID Controller Module, Инструкция по установке и эксплуатации

Страница: 29 / 216

Chapter 4. Installing the IBM BladeCenter S SAS RAID
Controller Module
This topic details the IBM BladeCenter S SAS RAID Controller Module installation
and setup procedures.
Before you begin
Before you begin, do the following:
1. Install a SAS Expansion Card (CFFv) for IBM BladeCenter (Part Number -
39Y9190) into each Blade server that you want to communicate with the RAID
Controller. For detailed installation instructions, see The SAS Expansion Card
(CFFv) for IBM BladeCenter Installation and Users Guide located in the
Support
directory on the support CD.
2. If you are upgrading ensure that your previously installed Advanced
Management Module has the level of firmware that supports the RAID
Controller. You can check your firmware level at: www.ibm.com/systems/
support/documentation/.
Note: If you log into the Advanced Management Module using the default IP
(192.168.70.125), your management system (the computer you are using to
manage your IBM BladeCenter S components) must be physically connected
through an Ethernet cable to the Advanced Management Module.
3.
As part of the setup procedure, obtain four unused IP Addresses on the same
subnet from your network administrator.
v
2 IP Address for the RAID Subsystem
v
2 IP Address for the SAS Switches
4. Remove the SAS RAID Modules from their shipping packages.
Remember: Follow the guidelines for handling static sensitive devices.
About this task
Once you have finished the prerequisite steps perform the following tasks:
Installation and setup
Procedure
1. Install one Battery Backup Unit in bay 1 of the media tray, and the second
Battery Backup Unit in bay 2 of the media tray.
© Copyright IBM Corp. 2008, 2013
19