IBM BladeCenter S SAS RAID Controller Module, Инструкция по установке и эксплуатации

Страница: 75 / 216

<CLI> configure timeout -[get | set <HR:MIN:SEC> | help]
Usage
: configure timeout -[get | set <HR:MIN:SEC> | help]
[-get] : Displays the CLI session timeout settings
[-set] : Sets the CLI session timeout period.
HR : Number of hours. The number must be less than two digits.
MIN : Number of minites. The number must be less than two digits.
SEC : Number of seconds. The number must be less than two digits.
Examples:
<CLI> configure timeout -set 00:01:30
Current Machine Local Time: 09/16/2011
03:54:33 AM
Error : configure timeout command failed
Note: The timeout period is less than two minutes.
<CLI> configure timeout -set 00:02:30
Current Machine Local Time: 11/16/2011
05:07:08 PM
CLI Session Timeout is set to 150 seconds
<CLI> configure timeout -set 00:00:00
Current Machine Local Time: 11/16/2011
05:07:21 PM
CLI Session Timeout is set to DISABLED
controller config
The controller config command is used for controller configuration. When this
command is issued, a config file is generated where settings are stored or
retrieved.
The two sections of the config file are:
v
System configuration - Contains drive pool, volume, spares, and host
configurations.
v
Controller settings - Contains read write and read only fields. The read write
fields contain cache settings (read and write cache enables), redundant mode,
port speeds, topology, and IP address/net mask. The read only fields contain the
controller World Wide Name (WWN), a unique 64-bit address used for
identification.
Issue this command with the
-load
option for the following:
v
Restore factory settings - This restores the factory default to the controller. Use a
file that contains factory settings as the config file. The factory settings are in the
Controller settings section of the file.
v
Canned Config - This quickly prepares a system for operation based on
predetermined settings. Use a file with a valid server and host configuration as
the config file.
v
Clone system - This uses the saved config file to program another system.
Issue this command with the
-save
option for the following:
v Clone system - This uses the saved config file to program another system.
v
Print configuration - This prints the configuration of the system to the config file.
You can read and edit the config file.
Issue this command with the
-get
option to print the config file information on the
screen for all config files.
Command arguments:
<CLI> controller config [ -save | -load | -get | -delete | -deleteall]
Chapter 8. Using the RAID Controller command line interface
65