HP Fabric OS v7.0.1, Руководство администратора

Страница: 322 / 584

284 Fabric OS Administrator’s Guide
53-1002446-01
Traffic Isolation Zoning over FC routers with Virtual Fabrics
12
Using D,I notation, the port numbers for the TI zones in the logical fabric and base fabric are as
follows:
Note that the base fabric zone contains a reference to port 1,3 even though the base switch with
domain 1 does not have a port 3 in the switch. This number refers to the port in the
chassis with
port index 3, which actually belongs to LS3 in FID 1.
Traffic Isolation Zoning over FC routers with Virtual Fabrics
This section describes how you can set up TI zones over FC routers in logical fabrics. Figure 45
shows two physical chassis configured into logical switches. The initiator in FID 1 communicates
with the target in FID 3 over the EX_Ports in the base switches.
FIGURE 45 Example configuration for TI zones over FC routers in logical fabrics
Figure 46 shows a logical representation of the configuration in Figure 45 . This SAN is similar to
that shown in Figure 38 on page 277 and you would set up the TI zones in the same way as
described in “Traffic Isolation Zoning over FC routers” on page 276.
Port members for the TI zone in logical fabric Port members for the TI zone in base fabric
8,8 F_Port
8,1 E_Port
3,3 E_Port
3,10 E_Port
5,16 E_Port
5,8 E_Port
9,5 E_Port
9,9 F_Port
1,3 E_Port for ISL in logical switch
1,10 E_Port for XISL
7,12 E_Port for XISL
7,14 E_Port for XISL
2,16 E_Port for XISL
2,8 E_Port for ISL in logical switch
= Dedicated Path
Base switch
Domain 1
LS3, FID1
Domain 3
Base switch
Domain 2
LS2, FID3
Domain 6
E
E
E EX
EX EX
E
F
EX
E
E
F
E E
= Ports in the TI zones
11
12
1
2
3
4
5
6
7
10
13
14
15
16