HP 4500G PWR 24-Port, Руководство по настройке

Страница: 914 / 1968

1-9
To do… Use the command… Remarks
Configure the default
MED value
default med med-value
Optional
0 by default.
Enable the
comparison of the
MED of routes from
different ASs
compare-different-as-med
Optional
Not enabled by default
Enable the
comparison of the
MED of routes from
each AS
bestroute compare-med
Optional
Not enabled by default
Configure
the MED
attribute
Enable the
comparison of the
MED of routes from
confederation peers
bestroute med-confederation
Optional
Not enabled by default
Configuring the Next Hop Attribute
You can use the
peer next-hop-local
command to specify the local router as the next hop of routes
sent to a MBGP iBGP peer/peer group. If load balancing is configured, the router specifies itself as the
next hop of route advertisements to the multicast iBGP peer/peer group regardless of whether the
peer
next-hop-local
command is configured.
In a “third party next hop" network, that is, the local router has two multicast eBGP peers in a broadcast
network, the router does not specify itself as the next hop of routing information sent to the eBGP peers
unless the
peer next-hop-local
command is configured.
Follow these steps to specify the router as the next hop of routes sent to a peer/peer group:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter BGP view
bgp as-number
—
Enter IPv4 MBGP
address family view
ipv4-family multicast
—
Specify the router as the
next hop of routes sent to
a peer/peer group
peer
{
group-name |
ip-address
}
next-hop-local
Optional
By default, the next hop of routes sent
to a MBGP eBGP peer/peer group is
the advertising router, while that of
routes sent to a MBGP iBGP peer/peer
group is not.
Configuring the AS-PATH Attribute
In general, MBGP checks whether the AS_PATH attribute of a route from a peer contains the local AS
number. If yes, it discards the route to avoid routing loops.