HP 4500G PWR 24-Port, Руководство по настройке

Страница: 655 / 1968

1-13
Disable Interfaces from Sending OSPFv3 Packets
Follow these steps to disable interfaces from sending OSPFv3 packets:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter OSPFv3 view
ospfv3
[
process-id
] —
Disable interfaces from
sending OSPFv3 packets
silent-interface
{
interface-type
interface-number
|
all
}
Required
Not disabled by default
After an OSPF interface is set to
silent
, direct routes of the interface can still be advertised in
Intra-Area-Prefix-LSAs via other interfaces, but other OSPFv3 packets cannot be advertised. Therefore,
no neighboring relationship can be established on the interface. This feature can enhance the
adaptability of OSPFv3 networking.
Enable the Logging of Neighbor State Changes
Follow these steps to enable the logging of neighbor state changes:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter OSPFv3 view
ospfv3
[
process-id
] —
Enable the logging of
neighbor state changes
log-peer-change
Required
Enabled by default
Configuring OSPFv3 GR
z
You cannot configure OSPFv3 GR after configuring OSPFv3 virtual links, becase they are not
supported at the same time.
z
The 4800G series switches are centralized devices that support IRF. They can act as a GR Helper
before forming an IRF; they can form a distributed chassis switch in a logical sense and act as a
GR Restarter after forming an IRF. Active and standby switchover in this document refers to the
switching of the master for IRF devices.
To prevent service interruption after a master/backup switchover, a GR Restarter running OSPFv3 must
complete the following tasks: