HP 4500G PWR 24-Port, Руководство по настройке

Страница: 1943 / 1968

1-6
z
If only one single-port interface module is installed, the device can be used only as Switch B or
Switch C in
Figure 1-4 , that is, the device should be at either end of a bus connection.
z
In this situation, because only one IRF port is needed on Switch B or Switch C, IRF-port 2 or
IRF-port 1 can be bound to any physical port on the device.
2) IRF port correspondence for two interface modules
z
Correspondence in non-aggregate mode
Figure 1-6
Correspondence in non-aggregate mode for two interface modules
When two dual-port interface modules are installed, if the correspondence is not in the aggregate mode,
you can bind an IRF port to any physical IRF port (
Figure 1-6 only shows one possibility). However, you
must ensure that the serial number of the physical IRF port bound to IRF-port 1 is smaller than that of
the physical IRF port bound to IRF-port 2, namely, the physical IRF port bound to IRF-port 2 should be
located on the right side of the physical IRF port bound to IRF-port 1. The two physical IRF ports bound
to the IRF ports can be located either on one interface module or on different interface modules.
z
If two single-port interface modules are installed, you need to bind IRF-port 1 to physical IRF port 1,
and IRF-port 2 to physical IRF port 3.
z
If one dual-port interface module and one single-port interface module are installed, the
correspondence is the same with that when you install two dual-port interface modules. In this
situation, IRF-port 2 or IRF-port 1 can be bound to any physical port on the device, because only
one IRF port is needed on Switch B or Switch C.
z
Correspondence in aggregate mode