HP 4500G PWR 24-Port, Руководство по настройке

Страница: 699 / 1968

1-24
[SwitchD-bgp] ipv6-family
[SwitchD-bgp-af-ipv6] peer 102::1 as-number 200
3) Configure route reflector
# Configure Switch C as a route reflector, Switch B and Switch D as its clients.
[SwitchC-bgp-af-ipv6] peer 101::2 reflect-client
[SwitchC-bgp-af-ipv6] peer 102::2 reflect-client
Use the
display bgp ipv6 routing-table
command on Switch B and Switch D respectively, you can find
both of them have learned the network 1::/64.
Troubleshooting IPv6 BGP Configuration
No IPv6 BGP Peer Relationship Established
Symptom
Display BGP peer information using the
display bgp ipv6 peer
command. The state of the connection
to the peer cannot become established.
Analysis
To become IPv6 BGP peers, any two routers need to establish a TCP session using port 179 and
exchange open messages successfully.
Processing steps
1) Use the
display current-configuration
command to verify the peer’s AS number.
2) Use the
display bgp ipv6 peer
command to verify the peer’s IPv6 address.
3) If the loopback interface is used, check whether the
peer connect-interface
command is
configured.
4) If the peer is not directly connected, check whether the
peer ebgp-max-hop
command is
configured.
5) Check whether a route to the peer is available in the routing table.
6) Use
the
ping
command to check connectivity.
7) Use the
display tcp ipv6 status
command to check the TCP connection.
8) Check whether an ACL for disabling TCP port 179 is configured.