HP 4500G PWR 24-Port, Руководство по настройке

Страница: 18 / 1968

2-10
Features Description
URPF
Unicast Reverse Path Forwarding (URPF) protects a network against
source address spoofing attacks. This document describes:
z
URPF Overview
z
URPF configuration
High Availability Volume
Table 2-7
Features in the High Availability volume
Features Description
VRRP
Virtual Router Redundancy Protocol (VRRP) combines a group of
switches (including a master and multiple backups) on a LAN into a virtual
router called VRRP group. VRRP streamlines host configuration while
providing high reliability. This document describes:
z
VRRP overview
z
IPv4-Based VRRP configuration
z
IPv6-Based VRRP configuration
Smart Link
Smart Link is a solution for active-standby link redundancy backup and
rapid transition in dual-uplink networking. This document describes:
z
Smart Link Overview
z
Configuring a Smart Link Device
z
Configuring an Associated Device
Monitor Link
Monitor link is a port collaboration function used to enable a device to be
aware of the up/down state change of the ports on an indirectly connected
link. This document describes:
z
Monitor Link Overview
z
Configuring Monitor Link
RRPP
RRPP is a link layer protocol designed for Ethernet rings. RRPP can
prevent broadcast storms caused by data loops when an Ethernet ring is
healthy, and rapidly restore the communication paths between the nodes
after a link is disconnected on the ring. This document describes:
z
RRPP overview
z
Creating an RRPP Domain
z
Configuring Control VLANs
z
Configuring Protected VLANs
z
Configuring RRPP Rings
z
Configuring RRPP Ports
z
Configuring RRPP Nodes
z
Activating an RRPP Domain
z
Configuring RRPP Timers
z
Configuring an RRPP Ring Group
DLDP
In the use of fibers, link errors, namely unidirectional links, are likely to
occur. DLDP is designed to detect such errors. This document describes:
z
DLDP Introduction
z
Enabling DLDP
z
Setting DLDP Mode
z
Setting the Interval for Sending Advertisement Packets
z
Setting the DelayDown Timer
z
Setting the Port Shutdown Mode
z
Configuring DLDP Authentication
z
Resetting DLDP State