HP 4500G PWR 24-Port, Руководство по настройке

Страница: 424 / 1968

1-16
To do… Use the command… Remarks
Configure the maximum
number of RIP packets that
can be sent at the specified
interval
output-delay time count count
Optional
By default, an interface sends
up to three RIP packets every
20 milliseconds.
Displaying and Maintaining RIP
To do… Use the command… Remarks
Display RIP current status
and configuration information
display rip
[
process-id
|
vpn-instance
vpn-instance-name
]
Display all active routes in
RIP database
display rip process-id database
Display RIP interface
information
display rip process-id interface
[
interface-type interface-number
]
Display routing information
about a specified RIP process
display rip process-id route
[
ip-address
{
mask
|
mask-length
} |
peer ip-address
|
statistics
]
Available in any view
Clear the statistics of a RIP
process
reset rip process-id statistics
Available in user view
RIP Configuration Examples
Configuring RIP Version
Network requirements
As shown in Figure 1-4 , enable RIPv2 on all interfaces on Switch A and Switch B.
Figure 1-4
Network diagram for RIP version configuration
Configuration procedure
1) Configure an IP address for each interface (only the IP address configuration for the VLAN
interfaces is given in the following examples)
# Configure Switch A.
<SwitchA> system-view
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] ip address 192.168.1.3 24
[SwitchA-Vlan-interface100] quit
[SwitchA] interface vlan-interface 101