HP 4500G PWR 24-Port, Руководство по настройке

Страница: 1025 / 1968

1-20
Follow these steps to enable embedded RP:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter IPv6 PIM view
pim ipv6
—
Enable embedded RP
embedded-rp
[
acl6-number
]
Optional
By default, embedded RP is
enabled for IPv6 multicast
groups in the default embedded
RP address scopes.
The default embedded RP address scopes are FF7x::/12 and FFFx::/12. Here “x” refers to any legal
address scope. For details of the scope field, see
Multicast Overview
of the
IP Multicast Volume
.
Configuring C-RP timers globally
To enable the BSR to distribute the RP-Set information within the IPv6 PIM-SM domain, C-RPs must
periodically send C-RP-Adv messages to the BSR. The BSR learns the RP-Set information from the
received messages, and encapsulates its own IPv6 address together with the RP-Set information in its
bootstrap messages. The BSR then floods the bootstrap messages to all IPv6 routers in the network.
Each C-RP encapsulates a timeout value in its C-RP-Adv messages. Upon receiving a C-RP-Adv
message, the BSR obtains this timeout value and starts a C-RP timeout timer. If the BSR fails to hear a
subsequent C-RP-Adv message from the C-RP when the timer times out, the BSR assumes the C-RP
to have expired or become unreachable.
The C-RP timers need to be configured on C-RP routers.
Follow these steps to configure C-RP timers globally:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter IPv6 PIM view
pim ipv6
—
Configure the C-RP-Adv
interval
c-rp advertisement-interval
interval
Optional
60 seconds by default
Configure C-RP timeout time
c-rp holdtime interval
Optional
150 seconds by default
For the configuration of other timers in IPv6 PIM-SM, refer to Configuring IPv6 PIM Common Timers .