HP 4500G PWR 24-Port, Руководство по настройке

Страница: 1822 / 1968

1-15
Be aware of the following issues while editing file
/etc/syslog.conf
:
z
Comments must be on a separate line and begin with the # sign.
z
No redundant spaces are allowed after the file name.
z
The logging facility name and the information level specified in the
/etc/syslog.conf
file must be
identical to those configured on the device using the
info
-
center loghost
and
info-center source
commands; otherwise the log information may not be output properly to the log host.
Step 4: After log file
info.log
is created and file
/etc/syslog.conf
is modified, you need to issue the
following commands to display the process ID of
syslogd
, kill the
syslogd
process and then restart
syslogd
using the
–r
option to make the modified configuration take effect.
# ps -ae | grep syslogd
147
# kill -HUP 147
# syslogd -r &
After the above configurations, the system will be able to record log information into the log file.
Outputting Log Information to a Linux Log Host
Network requirements
z
Send log information to a Linux log host with an IP address of 1.2.0.1/16;
z
Log information with severity higher than informational will be output to the log host;
z
All modules can output log information.
Figure 1-2
Network diagram for outputting log information to a Linux log host
Configuration procedure
Before the configuration, make sure that there is a route between Device and PC.
1) Configure the device
# Enable information center.
<Sysname> system-view
[Sysname] info-center enable
# Specify the host with IP address 1.2.0.1/16 as the log host, use channel
loghost
to output log
information (optional,
loghost
by default), and use
local5
as the logging facility.
[Sysname] info-center loghost 1.2.0.1 channel loghost facility local5
# Disable the output of log, trap, and debugging information of all modules on channel
loghost
.