HP 4500G PWR 24-Port, Руководство по настройке

Страница: 1593 / 1968

1-8
To do… Use the command… Remarks
Enter system view
system-view
—
Configure the source IP
address of BFD echo
packets
bfd echo-source-ip ip-address
Required
By default, no source IP
address is configured for
BFD echo packets.
Enter interface view
interface interface-type
interface-number
—
Enable BFD on the RIP
interface
rip bfd enable
Required
Disabled by default.
Bidirectional detection in BFD control packet mode
Follow these steps to configure BFD for RIP (bidirectional detection in BFD control packet mode):
To do… Use the command… Remarks
Enter system view
system-view
—
Create a RIP process
and enter RIP view
rip
[
process-id
] [
vpn-instance
vpn-instance-name
]
Required
By default, RIP is disabled.
Specify a RIP neighbor
peer ip-address
Required
By default, RIP does not
unicast updates to any peer.
Enter interface view
interface interface-type
interface-number
—
Enable BFD on the RIP
interface
rip bfd enable
Required
Disabled by default
z
Unidirectional detection in BFD echo packet mode only works for RIP neighbors that are directly
connected, namely, one hop away from each other.
z
Using the
undo peer
command does not remove the neighbor relationship at once and therefore
cannot bring down the BFD session at once.
z
For RIP configuration, refer to
RIP Configuration
in the
IP Routing Volume
.
Configuring BFD for BGP
The default BGP keepalive interval is 60 seconds and can be configured as 1 second at least. Thus, the
holdtime is 180 seconds by default and three seconds at least. This makes the detection of neighbor
relationships rather slow, and a large quantity of packets will be dropped when being transmitted or
received through a high-speed interface. BFD quickly detects neighbor relationships and reduces
network convergence time. Before configuring BFD for BGP, you need to enable BGP.
Follow these steps to enable BFD for a BGP peer: