1-10
To do...
Use the command...
Remarks
Configure an IGMP version on
the interface
igmp version version-number
Optional
IGMPv2 by default
Configuring Static Joining
After an interface is configured as a static member of a multicast group or a multicast source and group,
it will act as a virtual member of the multicast group to receive multicast data addressed to that multicast
group for the purpose of testing multicast data forwarding.
Follow these steps to configure an interface as a statically connected member of a multicast group or a
multicast source and group:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Enter interface view
interface interface-type
interface-number
—
Configure the interface as a
static member of a multicast
group or a multicast source and
group
igmp static-group
group-address
[
source
source-address
]
Required
An interface is not a static
member of any multicast group
or multicast source and group
by default.
z
Before you can configure an interface of a PIM-SM device as a static member of a multicast group
or a multicast source and group, if the interface is PIM-SM enabled, it must be a PIM-SM DR; if this
interface is IGMP enabled but not PIM-SM enabled, it must be an IGMP querier. For more
information about PIM-SM and a DR, refer to
PIM Configuration
in the
IP Multicast Volume
.
z
As a static member of a multicast group or a multicast source and group, the interface does not
respond to the queries from the IGMP querier, nor does it send an unsolicited IGMP membership
report or an IGMP leave group message when it joins or leaves a multicast group or a multicast
source and group. In other words, the interface will not become a real member of the multicast
group or the multicast source and group.
Configuring a Multicast Group Filter
To restrict the hosts on the network attached to an interface from joining certain multicast groups, you
can set an ACL rule on the interface as a packet filter that limits the range of multicast groups the
interface serves.
Содержание 4500G PWR 24-Port
