Hokkaido HCND 261 G, Инструкция по эксплуатации

Страница: 26 / 104

IG-24
Monosplit “Wall” Personal Line Constant Speed - Section 1: General Information
1.9 EMERGENCY OPERATION & “SELF-CHECK”
Frontal panel
Access to Emergency Button:
For reaching Emergency Button, open frontal
panel.
Opening of frontal panel:
Seize both side ends of frontal panel. Pull the
panel towards you and lift it till hearing the
click of limit end. Do not force the opening of
panel because this causes the breaking of
hinges.
Closing of frontal panel:
Seize both side ends of frontal panel, and
pull it down towards Indoor U nit’s b ody.
Gently push the panel till completely closing
it.
Emergency Operation:
If remote control is temporarily unavailable or batteries are exhausted, nevertheless it is possible to use
the air conditioner by pressing Emergency Button once while the system is OFF.
In this way, Emergency operation in “AUTO” mode will be started up, and the system will operate in the
most suitable mode according to temperature conditions inside the room, with temperature value (the
so-called “set point” ) set to 25°C (not modifiable value).
In particolar, it occurs the following:
If room temperature is lower than 21°C, operation in “HEAT” mode will be selected.
If room temperature is 21°C ~ 26°C, operation in “FAN” mode will be selected.
If room temperature is higher than 26°C, operation in “COOL” mode will be selected.
End of Emergency Operation
Press Emergency Button again during Emergency operation: system’s operation will be stopped (OFF).
Besides, during Emergency operation it is sufficient to press ON/OFF button on remote control to restore
normal operation of system.
“Self-Check” Mode (quick autodiagnosis of malfunctions)
You can enter this diagnostic mode by connecting the system through main power switch, and at the same
time by pressing Emergency Button on Indoor Unit.
Emergency Button