Hokkaido HCND 261 G, Инструкция по эксплуатации

Страница: 78 / 104

IN-22
Monosplit “Wall” Personal Line Constant Speed - Section 5: Installation
Overall view of installation
Notes:
1.
When chased laying is carried out of refrigerant pipings, take care to seal the ends of these
refiìrigerant lines, by pinching and welding them so as to protect them from infiltrations.
2.
Check if chosen pipings have such diameters and features (copper thickness) as to be suitable to
Units which belong to system and to R410A refrigerant.
Finishing of installation: strictly tape insulating
material that wraps refrigerant pipings, by
proceeding from the bottom upwards.
Cover the pipings with closed cells’ insulation
material, resistant to temperatures of at least
120°C. It is important that there is no air pocket
between insulating material and material which
wraps refrigerant pipings.
1.
If there is the risk Outdoor Unit may fall down or overturn, it is advised to install tie rods in addition
to anchor bolts (4 x Ø8mm, or 4 x Ø10mm) on Indoor Unit’s base.
2.
The installation of a raised bearing bed as regards ground prevents snow from piling up around
Outdoor Unit, and at the same time it makes easier condensate and defrosting water drainage.
3.
Take care to fix Outdoor Unit by keeping it leveled as regards horizontal surface.
Outlet direction of pipings
Left
Rear-left
Rear-right
Right
Drain hose must
never go up
NO
Drain hose
Refrigerant
pipings
More than 30 cm
More than 2m
More than 30 cm
More than 60 cm
Fixing plates
Indoor Unit
Outdoor Unit (Example: HCND 351 G)
Electrical
wiring
IR Remote Control
Mod. HKED 261 G Mod. HKED 351 G Mod. HKED 531 G
A
B
C
NOTE: at least 2 of sides
that are indicated in the
Figure by “A”, “B” and “C”
must be kept free from
obstacles.
D