Hitachi SJ300 Series, Инструкция по эксплуатации

Страница: 241 / 294

SJ300 Inverter
T
roub
leshooting
and Maintenance
6–17
IGBT Test Method
The following procedure will check the inverter transistors (IGBTs) and diodes:
1. Disconnect input power to terminals [R, S, and T] and motor terminals [U, V, and W].
2. Disconnect any wires from terminals [P] and [RB] for regenerative braking.
3. Use a Digital Volt Meter (DVM) and set it for 1 ohm resistance range. You can check the
status of the charging state of terminals [R, S, T, U, V, W, RB, P, and N] of the inverter and
the probe of the DVM by measuring the charging state.
Almost infinite ohms = “non-conducting,” and 0 to 10 ohms = “conducting.”
NOTE:
The resistance values for the diodes or the transistors will not be exactly the same, but
they will be close. If you find a significance difference, a problem may exist.
NOTE: Before measuring the voltage between [P] and [N] with the DC current range, confirm
that the smoothing capacitor is discharged fully, then execute the tests.
Circuit Type
DVM Probe
Measured Value
+ –
Converter
D1 R PD Non-conducting
PD R Conducting
D2 S PD Non-conducting
PD S Conducting
D3 T PD Non-conducting
PD T Conducting
D4 R N Conducting
N R Non-conducting
D5 S N Conducting
N S Non-conducting
D6 T N Conducting
N T Non-conducting
Inverter
TR1 U P Non-conducting
P U Conducting
TR2 V P Non-conducting
P V Conducting
TR3
W P Non-conducting
P W Conducting
TR4 U N Conducting
N U Non-conducting
TR5
V N Conduct
N V Non-conducting
TR6 W N Conducting
N W Non-conducting
Dynamic
Braking
(0.4kW–11kW)
TR7 RB P Non-conducting
P RB Conducting
RB N Non-conducting
N RB Non-conducting
R
S
T
D1 D2 D3
D4 D5 D6
U
V
W
TR1 TR2 TR3
TR4 TR5 TR6
PD P RB
C
TR7
+
Converter Inverter
N