GSK 980TDi, Руководство пользователя

Страница: 443 / 570

Official GSK Agents in South Africa
Tel: +27 11 626 2720, design@efamatic.com
Chapter 2 Definition and Connection of Interface Signal
427
Ⅲ
Connection
2.9.28 Working Indicator
z Relative signals
Signal
type
Symbol
Signal
interface
Address Function description Remark
Output
signal
WKLP CN62.39 Y3.2
Working indicator
output
z Relevant parameters
PLCStatus parameters
K 1 3 WKLP
WKLP =1: Working indicator control enabled.
=0: Working indicator control disabled.
z Function description
The working indicator outputs pressing once; it closes by pressing it again.
2.9.29 Gear/tool Number Display
z
Signal diagnosis
Y0025 BIT7 BIT6 BIT5 BIT4 BIT3 BIT2 BIT1 BIT0
Corresponding
BCD code
LED1
2
3
LED1
2
2
LED1
2
1
LED1
2
0
LED0
2
3
LED0
2
2
LED0
2
1
LED0
2
0
LED 0 displays the current tool number, BIT0~BIT3 of PLC diagnosis number Y25 are BCD code
of the current tool number; LED 1 displays the gear of the current spindle, BIT4~BIT7 of PLC
diagnosis number Y25 are BCD code of the current spindle gear and is shown below:
z Function description
① When the tool count is less than 10, the gear and the tool number separately use one LED to
display.
②
When the tool count is more than 10, LED 1 displays 10-digit numbers and the LED 0
displays the single digits.
③
When the gear and the tool number are displayed in time-division, that is, the gear instead of
the tool number is firstly display, the tool number instead of the gear is displayed after 1.5S, and the
system executes them like the above cycle.
2.10 Commonly Use Sign of Electricity Drawing
GSK980TDi DC24V power supply and the electromagnetic valve with power working current
separately use DC24V, and the electronic component explanations are as follows: