GSK 980TDi, Руководство пользователя

Страница: 298 / 570

Official GSK Agents in South Africa
Tel: +27 11 626 2720, design@efamatic.com
GSK980TDi Turning CNC System User Manual
282
Ⅱ
Operation
(2) G50, G52-59 are denoted with coordinate systems, color: Green;
(3) M, S and T commands are shown by Yellow dot; the M30, M99, M00, M01 and M02 are not
displayed near the note M, S, T and M codes;
(4) G31/G36/G37 are treated as G01;
(5) The path at the G17, G19 plane can not be regarded as the path preview;
(6) The writ of the system variable in the macro program does not register to the cutter
compensation file; the read for the system variable, is the state, before entering to the program
preview;
(7) Enter to the polar coordinate, cylinder interpolation, the graph is shown be Red;
If the polar coordinate and cylinder command are programmed in the G17 and G19 planes, at
last, the graph is shown in the X, Z planes
。
The difference between the displayed graph and the actual one of the programmed path are 90
degrees (The coordinate system of drawing can be consistent with the one of the programming by
adjusting the data parameter No. 175 and pressing the [SHIFT] soft button). The example program
(G17 panel) of the polar coordinate interpolation in this Manual can be illustrated as follows:
If the polar coordinate and the cylinder command are programmed in the G18 plane, but the
eventual graph displays in the X, Y plane 。
The displayed graph and the programmed one are symmetric (The coordinate system and
programming system based upon drawing can be consistent by adjusting the data parameter 175) to
Z axis to describe the example program (G18 plane) in the cylinder interpolation; refer to the following
figure: