GSK 980TDi, Руководство пользователя

Страница: 333 / 570

Official GSK Agents in South Africa
Tel: +27 11 626 2720, design@efamatic.com
Chapter 9 AUTO Operation
317
Ⅱ
Operation
workpiece coordinate system will not renew; that is, the coordinate system position before the MPG
interruption will not recover, the workpiece coordinate offset generated in the MPG interruption will
always enabled, and then can not be recover again.
9.4.5 Precaution of MPG Interruption
1) MPG interruption is disabled when the MPG feed (Including the Manual, MPG, Single-step,
Machine tool zero return or program zero return) is performed;
2) The axis is controlled by PLC axis; MPG interruption is disabled.
3) MPG interruption is disabled when MPG trial-cutting is performed.
4) The axis does not move when the machine is locked, and the MPG interruption is disabled.
5) MPG interruption is disabled when returning the reference position.
6) MPG interruption is disabled when the system alarm occurs.
Note: The MPG interruption disabling are on the states 1)
～
3), as the above-mentioned, the system will
not enter to the MPG interruption state. If it on the states 4)
～
6), the system can be entered to the MPG
interruption state, instead of generating the enabled MPG interruption value.
9.5 Other Operations
1. In Auto mode, press key to switch on/off the cooling;
2. Press any of the , , , , , , keys to switch the operation
modes;
3. Press the key to reset this CNC system.
4. Automatic lubricating operation (Refer to OPERATION, Chapter 3 ).