GSK 980TDi, Руководство пользователя

Страница: 254 / 570

Official GSK Agents in South Africa
Tel: +27 11 626 2720, design@efamatic.com
GSK980TDi Turning CNC System User Manual
238
Ⅱ
Operation
2.4.2 ESP
During machine running, if the ESP button is pressed under the dangerous or emergent situation
(external SP signal active), the CNC system enters into emergency status and the machine
movement is stopped immediately. All the outputs such as the spindle running, cooling are cut off. If
the emergency button is released, the emergency alarm is cancelled and the CNC resets.
Note 1: The ESP alarm generates during the operation of the machine tool, Re-perform the machine zero
return to get the correct position coordinate after the emergency alarm is cancelled (machine zero
return is forbidden if there is no machine zero on the machine.).
Note 2: Only Bit3 of the bit parameter No.172 is set to 0, is the external emergency stop active.
2.4.3 Feed Hold
Press key during the machine running to make the running pause. However, in threading
cutting, tapping cycle state, the function cannot stop the running immediately.
2.4.4 Power-Off
Under the dangerous or emergency situations during the machine running, the machine power
should be cut off immediately to avoid the accidents. But it should be noted that there may be a large
error between the CNC coordinates displayed and the actual position. So the tool-setting operation
should be performed again.