GSK 980TDi, Руководство пользователя

Страница: 235 / 570

Official GSK Agents in South Africa
Tel: +27 11 626 2720, design@efamatic.com
Chapter 1 Operation Mode and Display Interface
219
Ⅱ
Operation
Basic information in POSITION interface (taking an example of the above figure):
9 G code : information of each G code;
9 M : last executed M code;
9
S :it is input spindle speed when analog spindle is executed, and input spindle’s gear
when the spindle is executed;
9 L : call times of subprogram;
9
F :the first half (0.0000mm/min) is the actual speed, and the second half (200mm/min)
is the command speed;
9 JOG F.( JOG speed): theory speed value of current override in JOG mode;
9 FED OVRI(Feedrate override):override selected by feedrate override switch;
9 RAD OVRI (Rapid override): display currently rapid override;
9 SPI OVRI (Spindle override): display the spindle override when NO.001 Bit1 is set to 1;
9 PART CNT(Part counting) : part counting adds 1; when program executes the M code set by
data parameter No.173;
9 CUT TIME: the system counts the time when the automatic run is started, time unit is hour,
minute and second in order.
2) RELATIVE POS display interface
Displayed U, W coordinates are the current position relative to the reference point, and they are
held on when power on. They can be cleared at any time. When No.005 Bit1=1, and the absolute
coordinates are set by G50, the relative coordinates are set simultaneously.
3) INTEGRATED POS display interface
4) POS&PRG display interface