ST-8
2. Installation of brush holder
(a)Put the brush holder on armature.
(b)To connect armature with the holder, screw tap may be used to press
the brush spring on the back. Beside, four brushes must be connected.
Note: Check and verify that the positive lead-wire
has not been connected with ground.
End cover may be installed using two screws.
3. Installation of steel ball into the axle hole of clutch
(a)Grease needs to be applied to steel ball.
(b)Steel ball shall be installed into the axle hole of clutch.
4. Installation of clutch assembly
(a)Grease needs to be applied to the release spring.
(b)Release spring shall be installed into the hole of solenoid switch.
(c)Following spare parts shall be installed into the starter shell.
a Clutch assembly
b Idler wheel and bearing
Starting system-Assembly of starter
ProCarManuals.com
Содержание GW491QE
