Great Wall GW491QE, Руководство по обслуживанию

Страница: 68 / 222

EF.1-49
3. List of criterion to the mounting torque of parts &components
S.N.
Name of parts
&components
Mounting torque
N·m
S.N.
Name of parts
&components
Mounting torque
N·m
1
Air inlet pressure
/temperature sensor
3.3 6 Rotating speed sensor 8±2
2
Cooling-fluid
temperature sensor
20(Max) 7 Phase sensor 8±0.5
3 Knock sensor 20±5 8 Oil injector 6
4 Oxygen sensor 50±10 9 Idle-speed actuator 4±0.4
5 Throttle position sensor 2±0.5
2 Steps to read flashing fault codes:
(a)Connect the engine ignition switch rather than to start the engine.
(b)Connect the diagnosis plug-7# on line K ECU-55# or OBD to ground, and the connection time is longer than 2.5
seconds.
(c)And failures stored in the failure memory will be output by a flashing fault indicator lamp.
(d)Each flashing code is composed of two digits, and each is made up of one number within 0 and 9.
(e)The digit 0 will flash for ten times, and any digit within 1-9 will flash as per its literal meaning; The flashing will be stopped
instantaneously for one second between two digits forming a flashing code, and will be stopped for a long-term period between
(f) An identical fault code will be flashing continuously for three times, and all fault codes will be uninterruptedly flashing until
(g)If no any failure has been stored in the failure memory, the fault indicator lamp will have the “No failure” (ie. “11”) flashed.
(h)To clear any fault code away from the failure memory, simply connect the K line to ground for two continuous times, and each time
shall be longer than 2.5 seconds.
Criterion to flashing codes and the mounting torque of parts &components within
M1.5.4 system
ProCarManuals.com