Great Wall GW491QE, Руководство по обслуживанию

Страница: 200 / 222

ST-7
2. The bearing may be changed if necessary.
(a)Use SST to remove the bearing
(b)Use SST and press tool to press new front bearing.
SST 09285-76010
(c)Use a press tool to press into rear bearing
1. Perform a pull-in winding test in an open circuit
An ohmmeter may be used to check whether conduction exists between
terminal 50 and terminal C.The solenoid switch needs to be changed
if non-conduction exists.
2. Perform a holding-power winding test in an open circuit
An ohmmeter may be used to check whether conduction exists between
terminal 50 and the switch unit.
The solenoid switch needs to be changed if non-conduction exists.
Assembly of starter
Note During the assembly of starter, bearings
and gears may be lubricated using high temperature
grease.
1. Installation of armature into the excitation frame
After the armature bearing is applied with greasete ar mature may be
inserted into the excitation frame.
switch unit
terminal 50
Solenoid switch
terminal C
terminal 50
Starting system-Assembly of starter
ProCarManuals.com