General Music S2 Turbo, Руководство пользователя

Страница: 167 / 304

151
Segment 1 rate dynamic sens. Response of Segment 1 of the Key On Envelope to dynamic variations. Segment 1 corre-
sponds to the Attack phase. This parameter ties the Attack of the Sound to dynamics.
Positive values increase the Attack rate with increased dynamics while negative values give
the inverse effect with increased dynamics.
Value range: -7 ... +7.
Key Off rate dynamic sens. Response of the Key Off Envelope to the release dynamics. The Key Off Envelope corre-
sponds to the Release phase. This parameter ties the Sound’s Release to the velocity with
which the notes are released (Note Off Velocity or Dynamic Off).
Positive values increase the completion speed of the Key Off Envelope with increased
release dynamics, while negative values slow it down with increased release dynamics.
Page 2: Amplitude Key On
Commands The option/command column shows specific options for this page.
set loop Activates the loop (envelope repetition). Determines the starting point of the
envelope repetition. When the envelope reaches its terminal point, it loops back to the
beginning. The cycle repeats continuously until you release the keys.
The loop is represented by an arrow which indicates the initial loop point.
To eliminate the loop, select its first segment again and then select “Set Loop”.
Note: You can programme a loop only if “Envelope finish” parameter (previous page) is set
to “Off”.
add segm Adds a segment. Inserts a new segment in the envelope curve immediately
after the currently selected segment. N.B.: a maximum of up to 10 segments is permitted.
del segm Cancels the segment selected. N.B.: The Key On Envelope must have at least
one segment (corresponding to Attack), which cannot be cancelled.
zoom in Enlarges the field of vision of the envelope up to 4 times.
zoom out Reduces the field of vision of the envelope; it also cancels a zoom in. Reduces
the envelope up to three times its standard size.
Parameters Tap
ENTER
to access the three parameters displayed under the Key On Envelope curve. Edit
the selected parameter with
DIAL
(“Time” and “Level” also with the
NUMERIC KEYPAD
).
segment One of the envelope segments (1 - 10), whose end point is selected.
time Duration of the Segment. The maximum segment time is approximately 21 seconds.
Value range: 0 ... 127.
level Sound level of the selected segment at its terminal point. The maximum level
corresponds to the volume programmed in the Volume editor
N.B.: the initial level of the first
segment is always zero (it cannot be modified).
Value range: 0 ... 127.
Detailed procedure…Follow these steps to access and modify the parameter:
1. Tap
ENTER
to select one of the parameters “Segment”, “Time”, “Level”.
2. Rotate the
DIAL
to select a segment or to modify its duration or level. You can
enter a “Time” and “Level” value on the
NUMERIC KEYPAD
.
3. Press
ENTER
to select the next parameter. After “Level” you will return to
“Segment”.
4. Select “Add segm.” to add a new segment after the selected segment. Select
“Del. segm.” to cancel the selected segment.
(5) Edit Sound