GCC Technologies S290LS Series, Руководство пользователя

Страница: 140 / 148

NOTE
• Mirrors should be removed for cleaning
one at a time
to avoid beam misalignment after
placing them back to the lens holders
• Refer to section 8.3.2 on how to clean the mirrors.
Thumbscrew
8.3 Cleaning the Optics System
8.3.1 Removing the Mirrors
We recommend that you check the mirrors once or twice a week to see if they require cleaning.
If any debris or smoke residue is present, use the following steps to clean them.
.
The following section will illustrate the location of the four mirrors found in the machine for
cleaning.
Mirror 1
This mirror is located inside the bottom left access panel of the LaserPro S290LS.
1) Use a #2 Phillips Screwdriver to remove the access panel located on the bottom left side of the
LaserPro S290LS.
2) Loosen the thumbscrew and remove the dust cover securing the mirror. (As shown in the picture
below).
3) Clean the mirror in the proper manner.
4) Place the mirror back to the optics holder after cleaning.
5) Tighten the thumbscrew.
6) Replace and secure the outer access panel.