GCC Technologies S290LS Series, Руководство пользователя

Страница: 137 / 148

Closing the SmartLID:
To properly close the SmartLID after you have finished accessing the work table or motion system,
please follow these steps:
1) Disengage both of the sliding locks found on each side of the metal support rails by sliding
them away from you and into the unlock position.
2) Push the SmartLID away from you and move to the maximum position to disengage the latch
(indicated by a small click) and gently close the SmartLID.
8.2.2 Cleaning the Work Table and Motion System
Clean the working table and the motion system on a weekly basis through the following steps:
1) Turn the power off and unplug the LaserPro S290LS before cleaning.
2) Use a vacuum cleaner with a flexible nozzle to remove dust and debris from the work table
and motion system.
3) Apply small amounts of all-purpose cleaner, alcohol, or acetone to a paper or cotton towel to
clean the working table.
4) Apply a soap solution, all-purpose cleaner, or alcohol to a paper or cotton towel to wipe down the rails
of the motion system.
5) Wait for all cleaning residue to dry completely before plugging in and operating the LaserPro
S290LS.
TIP
Please clean the AutoFocus pin each time after completing the engraved job to make sure the
AutoFocus pin is free to move
CAUTION
• Never pour or spray alcohol or acetone directly to the work table.
• Oil, alcohol and acetone can cause fires or smoke build-up if improperly used.
8.2.3 Lubrication of the Y Rails
In order to keep the motion system running smoothly, the Y rails of the motion system will need lubrication
on a weekly basis. Use a small amount of light grade machine oil or PS2 grease to a paper or cotton towel
and apply to the rails.
You can purchase PS2 grease from NSK dealers worldwide. Please visit
http://www.nsk.com
for additional
information.