GCC Technologies S290LS Series, Руководство пользователя

Страница: 100 / 148

232001410G(10)
96
5.2.3.3 LaserPro S290LS Print Driver >> Advanced Page
Scaling (Advanced Page) [DEFAULT SETTING: 0]
In some cases you may find a slight output inaccuracy in the actual output compared to what
you have set in the computer. This margin of error or offset is extremely small (approximately
1/300). What this means is that there may be a 1-unit offset for every 300 unit increments. As an
example, if you engrave a 300mm straight line, it may end up measuring only 299 mm or 301
mm in the
final output. In this case, you will want to set the scaling setting to +1/1000 or -1/1000
respectively
to compensate. A general rule of thumb is for every 300 unit increment, you will want to
adjust the slider by +1 if the final output is 1 unit increment shorter or -1 if the final output is
1 unit increment longer than your graphic design setting.
Position Modes (Advanced Page) [DEFAULT SETTING: Home]
These selections allow you to control the positioning of the laser head after each job
completion and before the next subsequent job.
•
Home:
Resets the positioning of the laser head to the ‘home position’ (upper-right)
before
and after each job.
•
Without Home:
The laser head will start the next job based on the position from its
graphic application software setting, from the last position of the previous job.
Upon completion of the current job, the laser head will remain at the last position of
the previous job.
•
Relative:
This mode sets the current laser head position to correspond to the
origin (top left) position of the graphic software. Therefore, the laser head will