GCC Technologies S290LS Series, Руководство пользователя

Страница: 14 / 148

232001410G(10)
10
NOTE
Each LaserPro S290LS machine is shipped with a single pair of safety
goggles. If additional safety goggles are required, please contact GCC directly
or an authorized GCC distributor. If you wish to purchase one on your own,
please make sure the safety goggles meet these requirements:
190 - 534 nm OD5+
910-1070 nm OD6+
Visible Light Transmission: 23.5%
• Connect the machine to a properly grounded power outlet. Ensure the voltage of the power
source is identical to the voltage of the machine.
• Do not open the laser access panel when the machine is plugged in.
• Do not attempt to modify or disassemble the laser module.
• Do not attempt to remove or modify any component of the machine’s laser interlock safety
system.
• Ensure the immediate work area of the machine is well-ventilated. Odors, vapors, and dust
are by products generated during the laser engraving and cutting process. An exhaust system,
vacuum cutting box, and honeycomb table are recommended. Please contact GCC or your
local GCC distributor for more information.
• Do not laser heat-sensitive surfaces or materials that may generate toxic fumes, such as PVC
and Teflon.
Regularly clean and maintain your machine according to our cleaning and maintenance instructions.
Doing so will ensure your machine will operate effectively and safely over a long period of time.
1.6 Operating Environment
Please follow the guidelines when considering a suitable location to set the LaserPro S290LS.
Improper work environments may lead to operational malfunction and/or unsafe working conditions.
The LaserPro S290LS should be placed and operated in a standard office-type environment.
•
Avoid environments where the machine is exposed to high levels of dust, temperature
(temperatures exceeding 30°C or 86°F) or humidity ( humidity exceeding 70% or where the
ambient temperature is near the dew point).
•
Avoid placing the machine in small enclosed areas with poor ventilation.
•
Avoid areas with high levels of electrical noise.
•
Select a location that is large enough to accommodate the LaserPro S290LS, an exhaust
system,
ġ
a computer and a work or storage table.
Select a location in which the ambient temperature remains between 15°C and 30°C (60°F to
86°F).
Select a location in which the relative humidity remains between 30% - 40%.
• Select a location in which there is a short, direct path to the fume exhaust system.
• Set the LaserPro S290LS on a floor surface that is completely even.
• Make sure your smoke or fire detection system in the immediate area is functioning.
• Setup the machine so that the back of the machine is at least 60 cm (2 feet) away from the wall in
order to assure proper ventilation.
•
ġġġ
Resulting debris from laser cutting are very dangerous and may cause fire hazard.