Foma N903i, Руководство пользователя

Страница: 75 / 580

73
Voice/Videophone Calls
■
To put an ongoing videophone call on hold
X
t
The hold tone sounds and the “
保留
Holding” image appears on the other party’s videophone screen.
Press
o
( ) or
r
to answer a videophone call on hold using a camera image, or
d
to answer the
call using a substitute image. Press
t
to answer the call in the condition before holding.
■
To mute voice to send during a videophone call (microphone mute)
X
a
(
R
) (1 second or longer)
“ ” appears while in mute. Video is transmitted as it is.
To cancel mute, press
a
(
R
) again for 1 second or longer.
2
To end the call, press
y
Changing a Call Between Voice and Videophone (the Other Party)
The mode of an ongoing call you have received can be changed by the caller (the other party).
d You can only change the call mode when you are a caller. When you have received a call, you cannot
change the call mode. (This function is available between terminals that support change between voice
call and videophone call.)
d
To enable a caller to change the call mode, “Ntfy switch-mode” must be set to “Indication ON” on the
caller’s phone beforehand.
→ p.89
d
Changing a call from voice to videophone (the other party)
1
In-call screen (p.53)
X
The other party changes the call mode
X
“YES”
While the call mode is being changed from voice to videophone, the screen showing that the call mode is
being changed appears and the voice guidance is given.
The call mode is changed to videophone and a camera image is sent to the caller.
■
To send a substitute image to the caller
X
“NO”
The specified substitute image is sent to the caller.
NOTE
e
Digital call charges still apply to a caller when a substitute image appears during a videophone call.
e
Even if “Call Forwarding” is set to “Activate”, a received videophone call can only be forwarded if the forwarding number
is a 3G-324M-compatible (p.52) videophone. Check the forwarding destination phone before setting up call forwarding.
e
If you receive a videophone call from a caller who is barred in the Nuisance Call Blocking service, the caller sees
the movie announcement showing that the call has been rejected and then the call ends.
e
Pressing
q
or
s
(MEMO/CHECK) while a FOMA terminal is ringing activates Record message to record the
other party’s message. (Pressing
q
also sets Manner mode.) → p.83
e
Incoming call operations for a videophone call during i-mode communication follows “V-phone while packet”. → p.89
e
You cannot receive i-mode mails, MessageR or MessageF during a videophone call. Mails you cannot receive are
held at the i-mode Center. Receive them using “Check new messages” after the videophone call ends.
e
You can receive SMS during a videophone call.
e
When you have subscribed to the “Call Waiting”, “Voice Mail” or “Call Forwarding” service and a videophone call
arrives while you are talking on another videophone call, end the ongoing call to answer the new call.
e
If the “Recharge battery” low voltage alarm appears on the display during a videophone call, the other party sees
the “
カメラオフ Camera Off” message and the call is disconnected roughly 20 seconds later. If you start charging
a battery before a videophone call is terminated, the call continues with the image that had been displayed before
the low voltage alarm was given.
e
A FOMA terminal does not ring and the incoming call lamp does not flash when “Public mode (Driving mode)” is
set. Received calls are logged in the Received calls record as missed calls.
e
Depending on the settings on a caller’s phone, you may receive a substitute image instead of a camera image.
Ｖ．ｐｈｏｎｅ
［Ｔａｌｋｉｎｇ］
１ｍ３０ｓ
１０ｓ
［Ｃｈａｎｇｉｎｇ］
１０秒
ＹＥＳ
ＮＯ
Ｃａｍｅｒａ ＯＮ／ＯＦＦ
ｉｎｄｉｃａｔｉｎｇ？
ｓｅｌｆ-ｐｏｒｔｒａｉｔ