Fluke 9100 Series, Руководство пользователя

Страница: 226 / 274

10.4-18 Section 10: Calibrating the Model 9100: AC Voltage Function
Hardware Spans Calibration Targets
Level Frequency
Default Minimum Maximum Default Minimum Maximum
0.000mV to 3.200mV 3.00000mV 1.80000mV 3.20000mV 40 35 45
3.00000mV 1.80000mV 3.20000mV 150 140 160
3.00000mV 1.80000mV 3.20000mV 1000 900 1100
3.00000mV 1.80000mV 3.20000mv 3000 2500 3000
3.21mV to 32.00mV 30.0000mV 18.0000mV 32.0000mV 40 35 45
30.0000mV 18.0000mV 32.0000mV 150 140 160
30.0000mV 18.0000mV 32.0000mV 1000 900 1100
30.0000mV 18.0000mV 32.0000mV 3000 2500 3000
32.1mV to 320.0mV 300.000mV 180.000mV 320.000mV 40 35 45
300.000mV 180.000mV 320.000mV 150 140 160
300.000mV 180.000mV 320.000mV 1000 900 1100
300.000mV 180.000mV 320.000mV 3000 2500 3000
0.321V to 3.200V 3.00000V 1.80000V 3.20000 40 35 45
3.00000V 1.80000V 3.20000 150 140 160
3.00000V 1.80000V 3.20000 1000 900 1100
3.00000V 1.80000V 3.20000 3000 2500 3000
3.201V to 7.500V 6.00000V 4.00000V 6.50000V 40 35 45
6.00000V 4.00000V 6.50000V 150 140 160
6.00000V 4.00000V 6.50000V 1000 900 1100
6.00000V 4.00000V 6.50000 3000 2500 3000
10.4.4.6 Calibration of Auxiliary AC Voltage (for Power Option)
Calibration Setup
1. Connections Ensure that the 9100 is connected to the Standards DMM as shown in Fig. 10.4.3.2, and that both instruments
are powered on and warmed up.
2. 9100 Ensure that the 9100 is in STANDARD CAL mode and then select Power and AC Volts by pressing the front-
panel AUX key followed by the softkey sequence
POWER
*
, W, , VOLTAGE .
Refer also to Fig. 10.2.2.
*
This keystroke is only required if one of the oscilloscope calibration options (Option 250 or Option 600) is
fitted.
Table 10.4.4.3: Auxiliary AC Voltage Calibration Points
AUX
CHANNEL
MODE