OBID i-scan
®
System-Manual
ID ISC.MR200
FEIG ELECTRONIC GmbH
Page 142 of 144
H40801-5e-ID-B.doc
Hex-value
Parameter Status
0x10
EEPROM-failure:
•
The EEPROM of the Reader is not able to be written on.
•
Before writing onto the EEPROM a faulty checksum of parameters has been detected.
0x11
Parameter-Range-Error:
•
The value range of the parameters was exceeded.
0x17
Firmware activation required:
The firmware must be activated first using ISOStart demo program and the command “Set
Firmware Upgrade”. The update code must be ordered by Feig Electronic.
1. Read the Device-ID using the command [0x66] Firmware version (Mode 0x80)
2. Send the Device-ID and the serial number of the reader to Feig Electronic
3. Write the upgrade code into the reader using the command [0x5F] Set Firmware Update
Hex-value
Interface Status
0x80
Unknown Command:
•
The Reader does not support the selected function.
0x81
Length-Error:
•
Protocol is too short or too long
0x82
Command not available:
•
0x83
RF communication error:
This error indicates that there is an error in communication between the Transponder
and the Reader. Reason for this can be:
•
The collision handling algorithm was not continued until no collision is detected, reasons
for the break:
- TR-RESPOSE-TIME in CFG1: Interface is to short
0x94
More Data:
•
There are more Transponder data sets requested than the response protocol can transfer
at once.
0x95
ISO 15693 Error:
•
An additional error code for ISO15693 Transponders is sent with response data.
Error-Code for ISO15693 Transponders
Hex-value
Response error code definition
0x01
The command is not supported, i.e. the request code is not recognized
0x02
The command is not recognized, for example: a format error occurred
0x03
The option is not supported
0x0F
Unknown error
0x10
The specified block is not available (doesn’t exist)
0x11
The specified block is already locked and thus cannot be locked again
0x12
The specified block is locked and its content cannot be changed
0x13
The specified block was not successfully programmed
0x14
The specified block was not successfully locked
0xA0 - 0xDF
Custom command error codes
all others
reserved for future use
