OBID i-scan
®
System-Manual
ID ISC.MR200
FEIG ELECTRONIC GmbH
Page 10 of 144
H40801-5e-ID-B.doc
1. Data Transmission between OBID i-scan
®
ID ISC.MR200 and Host
Different ways of data transmission between OBID i
-scan
®
Readers and host (terminal, PC) are pos-
sible. The
ISO15693Host Commands
are used for the data exchange between Transponder and
host, whereas the
Configuration Commands
and the
Control
serves for adapting the Reader pa-
rameters to the individual range of applications. The following chart shows which method of data
transmission is supported by which interface:
asynchronous interface
(RS232 / RS485)
Configuration Commands
√
Reader Control Commands
√
ISO15693 Host Commands
√
1.1. Configuration Commands and Control Commands
This method of data transmission is used for Reader configuration and the diagnosis via the asyn-
chronous interface or Ethernet Interface
The Reader-configuration parameters will be stored in the Reader memory. To store the current con-
figuration during a power down of the Reader the Reader-Configuration has to be stored in the
EEPROM. After power up the Reader reads the configuration out of the EEPROM.
The Reader control is immediately processed and the response from the Reader contains status or
data information of the control command.
Host (Terminal / PC / ....)
Reader
parameter- / control command
→
parameter received and stored / control
command processed
yes
no
←
status /
data
error status
←
