OBID i-scan
®
System-Manual
ID ISC.MR200
FEIG ELECTRONIC GmbH
Page 61 of 144
H40801-5e-ID-B.doc
3.24. CFG43: WLAN Settings, Part 2 (not used for ID ISC.MR200-A / -E / -EP)
Byte
0
1
2
3
4
5
6
Contents
SUBNET-MASK-WLAN
KEEPALIVE
KEEP-CNT
GW-ADDRES-WLAN
Default
0xFF
0xFF
0x00
0x00
0x00
0x00
0x00
255
255
0
0
Byte
7
8
9
10
11
12
13
Contents
GW-ADDRES-WLAN
KEEP-IDLE
KEEP-INTERVAL
Default
0x00
0x00
0x00
0x00
0x00
0x00
0x00
SUBNET_MASK_WLAN:
Defines the subnet mask for wireless TCP/IP connection. Changing of this parameter only be-
comes effective after writing / saving this configuration block to EEPROM and a [0x64] System
Reset of the WLAN-adapter.
GW_ADDRESS_WLAN:
Defines the gateway address for wireless TCP/IP connection. Changing of this parameter only
becomes effective after writing / saving this configuration block to EEPROM and a [0x64] Sys-
tem Reset of the ACC.
KEEPALIVE:
0x00: keepalive option disabled
0x01: keepalive option enabled
KEEP-CNT:
Specify the maximum number of retransmissions. This is the number of times that the reader
re-transmits a keepalive packet to the host to check for connectivity. The valid range is 5..30.
KEEP-IDLE:
The time the connection needs to remain idle before the reader starts sending keepalive
probes. The valid range is 10..65535 sec.
KEEP-INTERVAL:
Set the Keepalive Interval. This is the polling frequency used to determine if a keepalive ex-
change is needed. This interval is used when the connection failed. The valid range is 10..75
sec.
Note:
The configuration pages CFG40-49 cannot be set to default using the command 0x83
Reset.
