FEI Quanta FEG 250, Руководство пользователя

Страница: 185 / 228

System Options: Heating Stage 1000 °C / Heating Stage 1500 °C
9-37
Cables
The Outer Cable is 4-ended cable connecting the outside of the
chamber feed-through plate with the HS controller and SSB board.
The greater / lesser spherical connector connects to the connector
labeled Heating stage / Cooling stage (this is used in case your
system enables both stages, to use only one cable). The 25-pin / 9-pin
connector connects to the HS Controller / SSB.
The Inner Cable is 3 or 4-ended cable connecting the inside of the
Chamber feed-through plate with the heating stage assembly. The 15-
pin connector goes to the appropriate inner feed-through plate
connector, the other ones connect connectors ascribed to the Heater,
to the Sample Bias and to the Thermocouple.
FIGURE 9-30 OUTER CABLE AND INNER CABLES
High Temperature GSED
The High Temperature GSED must be installed if the heating stage is
going to be operated above 500 °C (up to 1500 °C), as the standard
GSED could be damaged at these conditions. It is a PLA cap (with
cone) which is pressed onto the standard insert. This cap comes with
a printed board adapter which plugs into the signal connector inside
the chamber. On the other end of this board is a wire which clips onto
the cap.
The detector is located just above the heat shield. Any working
distance can be used.
FIGURE 9-31 HIGH TEMPERATURE GSED
Note:
The operating characteristics of the GSED and the high temperature
GSED are slightly different.
Installing the High Temperature GSED
1. Vent the specimen chamber and open the stage door.