FEC Handheld Nutrunner HFC3000, Инструкция по эксплуатации

Страница: 80 / 231

Chapter 6 Fastening Operation
PAGE 6-10
6-2-3 Fastening Result Display Mode
The following data is displayed in Fastening Result Mode.
In the fastening result mode, “r.” is indicated
at the 100s digit of the PAR No. indication part and the parameter No. (01 to 64) of the fastening
operation that was performed is indicated by the 10s and 1s digits. By pressing the [
▲] or [▼]
push-
button, the “D-NO” can be changed ±1. The numbers can be advanced 5 at a time by holding the
[
▲] or [▼] push-button longer. *If fastening has not been started, “r.00” is displayed.
“WORK” “COUNT/D-NO” “DATA”
Peak Torque
Final Angle
Rate 1
ACCEPT count
Please refer to the “List of Contents Displayed in the Real Time Mode” on the next page regarding the
respective data contents indicated in the DATA Display
when “COUNT/D-No.” is changed.
■
Rate 1 (Low)
■
1st NG Item (300=Rate 1)
■
Rate 1/2/3 Judgment (Rate 1 low)
■
Number of Fastening Steps
■
Fastening Method (Torque Method)
■
Reverse Flag
・
The displayed content of the following D-Nos. are not stored in the fastening
result data of the controller.
D-
No. 12 “Fastening Method,” D-No. 13 “Number of Fastening Steps,”
D-
No. 14 “Self-Checking Flag,” D-No. 15 “Reverse Flag,” and
D-
No. 15 “Servo Lock Flag.”
～
3 6
0 2
0 1
0 0
r 0 1 ～
r 6 4
ｃ
[
▲
] or [
▼
] button
(skip 5 at a time by holding down)
Caution