FEC Handheld Nutrunner HFC3000, Инструкция по эксплуатации

Страница: 111 / 231

Chapter 6 Fastening Operation
PAGE 6-41
Item D-No. Contents
Setting
change
Unit
Connected
Tool Settings
100
Connected Tool No.
101
Connected Tool Information “015-P1”
102
Connected Tool CAL Torque Decimal Point Position
103 Connected Tool CAL Torque Nm
104 Connected Tool CAL Voltage V
105
Connected Tool ZERO Voltage
V
106 Connected Tool Internal Gear Ratio (×100)
107
Connected Tool Serial No. (upper 3 digits)
108
Connected Tool Serial No. (lower 4 digits)
109 Connected Tool Rotation Direction
110
Connected Tool Order No. (upper 2 digits)
111 Connected Tool Order No. (lower 5 digits)
112 Connected Tool Cycle Count (×1 million)
113 Connected Tool Cycle Count (×1)
114 Connected Tool Maximum Current A
Controller
Information 2
200
controller Setting Tool No.
○
201 controller Setup
Tool Information “015M50”
202
Parameter Setting File Version
203
Sequence Setting File Version
204 PLC Output Layout Setting File Version
205
Fieldbus Setting File Version
206 Fieldbus Message Setting File Version
207 RS232C Input/Output Setting File Version
208 controller RS232C-1 Communication Speed bps
209 controller RS232C-1 Parity
210 controller RS232C-1 Stop Bit bit
211 controller RS232C-1 Word Length bit
Option
Information1
300 Connected Fieldbus Information
301 ANYBUS-CC Version
302 controller Setting Fieldbus Information
303 Station No. (Node Address) (1 ~ 64 or 0 ~ 63)
304
Communication Speed (0 ~ 4)
305 Occupied Stations (1, 2, 3, 4)
306
Extended Cyclic Setting (1, 2, 4, 8)
307 I/O Setting
Byte Length “PLC
￫
MASTER Axis”
308
I/O Setting
Byte Length “Master Axis
￫
PLC”
309 Message Block Byte Length
310
Message Setting
Byte Length “PLC
￫
MASTER Axis”
311
Message Setting
Byte Length “Master Axis
￫
PLC”
312
IP Address (upper 6 digits)
313
IP Address (lower 6 digits)
314
Subnet Mask (upper 6 digits)
315
Subnet Mask (lower 6 digits)
316
Gateway (upper 6 digits)
317
Gateway (lower 6 digits)