FEC Handheld Nutrunner HFC3000, Инструкция по эксплуатации

Страница: 78 / 231

Chapter 6 Fastening Operation
PAGE 6-8
●
List of Contents Displayed in the Real Time Mode
WORK
COUNT/
D-NO
DATA Unit
Non.
0
【
Torque value display
】
The torque value from the torque transducer is displayed in real time.
The torque voltage that is converted to the full scale torque is output by
pressing [CAL] pushbutton.
Nm
1
【
Torque voltage display
】
The torque signal voltage from the torque transducer is displayed in real
time.
The torque voltage with about Δ3.7V potential difference is output by
pressing [CAL] button.
mV
2
【
Peak torque value display
】
(Peak torque value hold)
The peak torque, measured since the last time the [RESET] button was
pressed, is displayed in real time.
When the [SET] pushbutton is pressed during this display, the motor is
locked for up to one minute allowing the spindle to be checked with a
torque wrench while displaying the reaction torque. Press RESET to
unlock the Motor before one minute has expired.
WARNING : Do not
repeat this procedure repetitively or the motor will overheat.
Nm
3
【
Angle rotation display
】
The rotation angle of the output shaft since the last time the display mode
was switched to Real Time Display Mode is displayed. Turning the tool
output square will also read in this mode.
deg
4
【
Overload factor
】
The current monitor load factor is displayed. If the load factor goes over
100, an overload “A08-10” abnormal occurs
％
5
【
Current value
】
The current value in amps is displayed.
A
6
【
I/O monitor
】
12 bits of the standard Inputs/Outputs are monitored and indicated as shown in
the diagram below.
When [DIP SW2: SW. No. 6] on the bottom of the controller is ON, the display will
be as shown in the diagram below (IO-OFF) (external input/output disabling
function).
When the SET button is held, the outputs can be forced ON (at 0.5 second
intervals) in the order of the standard Outputs (bit 0 ... bit 11 from the left).
When [↑], [↓], [→], [←], or [SET] is pressed in the middle of forced outputs, the
forced output will end.
During forced output, fastening operation is halted.
Standard Input monitoring can be performed even during the use of forced
outputs.
7
【
ZERO / CAL Voltage Error Warning
】
If the CAL voltage or ZERO voltage, measured when the control power is
activated, when the self-check is performed at the start of fastening, when
the CAL button of the indicator is pressed, or when the RESET signal is
turned
“ON,” is of an error warning value, the indication (V Warn) shown in
the drawing below will be indicated. When the RESET signal is turned
“ON” after the warning indication, the [------] is re-indicated.
8
【
Tool Rotation Speed display
】
The current rotation speed is indicated in real time during the operation of
the tool. (Max. speed is displayed while motor is stopped)
RPM