FEC Handheld Nutrunner HFC3000, Инструкция по эксплуатации

Страница: 79 / 231

Chapter 6 Fastening Operation
PAGE 6-9
9
[Tool Response
•St1.] (0~255) Factory Adjustment only
10 [Tool Response
•St2.] (0~15) Factory Adjustment only
11
[Tool Response
•Ad1.] (0~255)
The actual sensing level of the starting trigger switch is indicated.
12
[Tool Response
•Ad2.] (0~255)
The actual sensing level of the F/R slide switch is indicated.
13
[Tool Response•G. Gyrosensor Shake Detection Angle]
-2048° ~ +2047°
Deg
14
[Tool Command•Ct1.] (0~255) (Factory Adjustment only)
CAL ON, GYRO RESET, etc.
15
[Tool Command
•Ct2.] (0~255) (Factory Adjustment only)
Angle conversion constant (fixed at 67)
16
[Tool Command
•LEd.] (0~255) (Factory Adjustment only)
LED-related command
17
[Tool Command
•BuZ.] (0~255) (Factory Adjustment only)
Buzzer-related command
18
[Tool Command
•Gan. Gyro Restriction Angle] (0~255)
Deg
19
[Fieldbus
•Status Monitor•FbS]
Fieldbus connection
condition: In the normal state, “4” is indicated.
Any other number indicates a disconnected state (STOP mode is activated and
operation is disabled).
20
[Angle Head Torque Variation [%]]
Displays the current torque variation rate of the angle head after the fastening
operation.
When the rate exceeds the value set in D-
No.541“[Angle Head Torque Variation]”,
A.09-
10 “Angle Head Torque Variation Abnormal” occurs.
%
21-25
Factory Adjustment Only
D-No. 006: External I/O Disabling Function
(DIP SW2: SW No. 6 is ON)
D-No. 7: ZERO/CAL Voltage Error Warning
D-No. 006: Simplified I/O Monitor
(DIP SW2: SW No. 6 is OFF)
Lit up during forced output (all digits).
Standard Inputs (lit up if ON)
bit0 ... bit11
Standard Outputs (lit up if ON)
bit0 ... bit11
AUX. Input (lit up if ON)
Batch reset input signal