FEC Handheld Nutrunner HFC3000, Инструкция по эксплуатации

Страница: 182 / 231

Chapter 9 Fieldbus I/O Interfaces
PAGE 9-2
9-1 Common Fieldbus Specifications
9-1-1 Fieldbus I/O signal specifications
①
INPUT signal format
[PLC → HFC3000]
The input signal is a fixed layout.
Word Byte
Singnal Name Connection Contents
No. Bit# No. Bit#
IN
No.01
0
IN
No.01
0 Unused NO Always off.
1 1 Unused NO Always off.
2 2 Unused NO Always off.
3 3 Unused NO Always off.
4 4 BANK SELECT NO
Fieldbus message bank reshuffling BIT.
In the case of CC-Link the top position of the message
data output can be changed (if data exceeds max
message size)
5 5 Unused NO Always off.
6 6 RESET NO
Executes the following operation by turning signal
“ON”.
・
Stop tightening process
・
Clears the PLC I / O fastening result output signals
(OFF)
・
Deletes any entered ID data
7 7
Unused Always off.(
～
V1.300)
ID SELECT
ENABLE
NO
WORK number selection by input ID is enabled setting
this signal
“ON” (FirmwareV1.301 ～
)
8
IN
No.02
0 Unused NO Always off.
9 1 Unused NO Always off.
10 2 Unused NO Always off.
11 3 Unused NO Always off.
12 4 Work Select Bit0 NO
Selects Parameter No.1~64 (Work Select 0~5)
13 5 Work Select Bit1 NO
14 6 Work Select Bit2 NO
15 7 Work Select Bit3 NO
IN
No.02
0
IN
No.03
0 STOP NO or NC Emergency Stop
1 1 RESET NO (See RESET signal above)
2 2 REVERSE NO Spindle will reverse (CCW) while
“ON”
3 3 START NO Starts fastening cycle
4 4 PROGRAM NO
Bypasses the controller
5 5
SELF CHECK
Disable
NO Disables self-check function
6 6 Unused NO Always off.
7 7 Unused NO Always off.
8
IN
No.04
0 Unused NO Always off.
9 1 Unused NO Always off.
10 2 Unused NO Always off.
11 3 Work Select Bit5 NO
Selects Parameter No.1~64 (Work Select 0~5)
12 4 BATCH OK RESET NO Resets Batch cycle count to 0.
13 5 Work Select Bit4 NO Selects Parameter No.1~64 (Work Select 0~5)
14 6 Unused NO Always off.
15 7
Unused
NO Always off.
* Work Select Bits 0 to 5 are enabled with the system parameter: SYS.034 [00xxx1].
(Continued on next page)